Light and Frames Assembly Roosevelt  
 
 
1.  Slide light frame over the top of the uprights.
 
Gently tighten the knob.
2.  If you have a plastic frame light, skip forward to 2b.
 
2a,  For steel frame lights, position with nylon fasteners (On top of light fixture) below the two holes in the frame.  Insert and tighten fasteners.
 
 
 
 
2b,  Install the two stainless steel brackets on the horizontal bar with the nut and lock washer on the top. (Change out the photo. The bolt hits the light the way you have it).
 
2c,  Position the light with the switch forward and on the left.  Snap the light to the frame.
 
  Additional Assembly  
     
 
Adjustable Top Shelf Overhead Light  
Back Mounted Power Strips Light Frame  
Nylon Drawers Bin Box Rail  
Uprights    
 
     
     

 

 
 
     

 

 
  Roosevelt Uprights Assembly  
 
 
1.  Slide upright bracket forward from the back until the two holes match up with the holes in the top.
 

2. Insert bolt with flat washer through from the top.  

 

3.  Add a washer, a lock washer, then a nut at the bottom of each screw, then tighten gently.

 
  Additional Assembly  
     
 
Adjustable Top Shelf Overhead Light  
Back Mounted Power Strips Light Frame  
Nylon Drawers Bin Box Rail  
Uprights    
 
     
     

 

 
 
     

 

 
  Roosevelt Nylon Drawer Assembly  
 
 
1.  Position the drawer and slides over pre-drilled holes or anywhere else.
 

2. Insert three screws on each side.  The seventh screw should be positioned near the front as a drawer stop. If you plan to use the drawer to carry product, do not insert the last screw.

 

  Additional Assembly  
     
 
Adjustable Top Shelf Overhead Light  
Back Mounted Power Strips Light Frame  
Nylon Drawers Bin Box Rail  
Uprights    
 
     
     

 

 
     

 

 

 


 
  Roosevelt Bin Box Assembly  
 
 
1.  First, consider the order you wish your options to be stacked on the uprights
 
2.  Select the option you wish positioned lowest on the uprights, then slide it down over the uprights as shown in the illustration.
 
3.  Align the attaching bracket so that the knob bolt will go into the dent in the back of the upright.  Tighten gently.
 
  Additional Assembly  
     
 
Adjustable Top Shelf Overhead Light  
Back Mounted Power Strips Light Frame  
Nylon Drawers Bin Box Rail  
Uprights    
 
     
     

 

 
 
     

 

 
  Top Shelves Assembly Roosevelt  
 
 
1.  Position the shelf brackets over the pre-assembled screws and with the flat sides facing the ends of the shelf. Tighten the screws.
 
 
2.  Slide the bracket forward so the shaft of the screw moves into the narrow part of the hole.
 
3.  Lift the shelf over the top of the uprights, then lower it into position.
4.  Position the knob shaft over a depression in the back of the upright, then tighten gently.
 
  Additional Assembly  
     
 
Adjustable Top Shelf Overhead Light  
Back Mounted Power Strips Light Frame  
Nylon Drawers Bin Box Rail  
Uprights