As low as
$642
Regular Price
$642
Model
RSDCR
Roosevelt Series Workbench Stainless Steel Frame with Cleanroom LisStat™ ESD Top Laminate and Bottom Laminate
- Meets ANSI, BIFMA, DIN and GSA Standards.
- Steel Reinforced Top.
- BenchPro™ Series Roosevelt Cleanroom Benches Meet and Exceed Class 100 Cleanroom Standards.
- BenchPro™ ESD Workbenches Include a Right and Left Sided Wrist-Strap Jack Plug and a 10' Long Green Grounding Wire.
- Undersides of Tops are Laminated with an Aluminum Sheet for Maximum Conductivity.
- 1,200 Lbs. Capacity.
- Ships 1-5 Days.
- Frame Grade 304 Stainless Steel, 16-gauge with #4 Brushed Finish.
- Height: Adjustable 30" to 36".
- 24 Torch Welds Strong!
Roosevelt Series Bench Assembly.
1. Place the unopened box on a small table with the seam tape facing up. Open the box, leaving the cardboard underneath.
Separate out the interior packaging. (This will save a lot of time)
Separate out the interior packaging. (This will save a lot of time)
2. Locate the bag of fasteners (Attached to one screw under the top). Insert one glide through the threaded hole in the bottom of the legs. Put the nut on the end of the inserted glide. No need to tighten now.
3. Find the front side of the legs and top. (Labeled Front). Place the top of the leg frame holes over the elevated screw heads, slide the base so the screw shafts slide into the slot. Tighten the screws.
4. The front of the legs have 1/4” holes. The back side of each leg has 4 smaller, threaded holes. Position the back bar over the threaded holes, insert screws and tighten. (There are no lock washers or nuts required here)
5. Turn it over.
6. See if the table wabbles due to an uneven floor. Lower one glide to stop the wobble. Now tighten the nuts on the glides.